Is it true that ZStack supports only eth0? If yes, why em01 is not supported? : ZStack International

Is it true that ZStack supports only eth0? If yes, why em01 is not supported? Print

Created by: ZStack Support

Modified on: Mon, 28 Mar, 2022 at 2:59 PM

ZStack identifies NIC names according to your configuration. The NIC No. of all compute nodes in the same cluster must be the same.

If you already added an eth0 L2 network, but the NIC of the new compute node is em01, not eth0, you will fail to add a host.
If you chose eth0 when you add an L2 network, you must configure the eth0 network for all compute nodes.
You can also set em01 as an L2 network. In this case, you must configure the em01 network for all compute nodes.
You can delete an L2 network and configure it again.

ZStack is the author of this solution article.

Did you find it helpful? Yes No

How can we help you today?